⁙ Home / Digital Cutter / Project / Tape Loader
This special cutter cuts the protective vinyl film of steel plate used for refrigerator exterior or ETC.
And this is a fully automated equipment from loading steel plate to unloading after cutting and revoming the film.
The material can be moved to a faster and more accurate location by using the shuttle transfer method instead of the conveyor belt.
Using KKT (Kisscut Knife Tool), only the protective vinyl film can be cut without damaging the steel plate underneath the film.
The loader has two units on the left and right with suction pads that can lift steel plate materials.
The two units can be operated together or separately depending on the size of the material. And there are 8 suction pads installed in one unit, and the suction position can be adjusted and suction can be turned on and off.
Loader carries the steel plate on the alignment table.
The two alignment blocks align the material according to the values set for each material size.
The protruding alignment stopper (called an" island") located in the middle of the table can be hided under the table when using wide sheet. In the case of materials with short width and different sizes, two sheets can be used at the same time by lifting the island over the table as an alignment stopper.
The shuttle under the table lifts the steel plate from the alignment zone and transports it to the next cutting zone.
In the cutting zone, KKT (Kisscut Knife Tool) can be used to cut only the protective vinyl without any damage to the steel plate.
The Film Remover automatically peels off the protective film of the steel plate kiss-cutted in the previous Kiss Cutting Zone.
At this time, the cylinder tongs specially made by DYSS pick up and lift the film clinging to the iron plate. And the suction tool (connected to the vacuum cleaner) next to the tong tool sucks up the film and carries it to the vacuum cleaner. Normally, the cylinderr tongs tool and suction tool are mounted on one head.
The buffer zone is where the material is waiting before unloading to the discharge table. While waiting, it provides time for other zones to perform their respective functions.
The unloader has the same structure and function as the loader.
The unloader unit lifts the material(s) waiting in the buffer zone and stacks them on the discharge table continuously.
Normally, the materials are stacked on a wooden pallet, and when the materials are piled up to a specified height, the machine is stopped by a sensor. At this time, the pallet is lifted by a forklift and transported to the designated location.
